Why Is The Suction Of The Vacuum Cleaner Motor Smaller?

　　What if the suction of the vacuum cleaner motor decreases? Reasons for the gradual decline of the suction power of vacuum cleaners and management solutions! Now many families have purchased vacuum cleaners, but many people find that after a period of use, the suction power of vacuum cleaners will gradually decrease, so there will be less suction power, vacuuming capacity, etc. At this time, if we want students to clean up better, we must immediately find out the cause and prescribe the right medicine.

　　The reasons for the reduction of vacuum suction are as follows:

　　The styles of vacuum cleaners are divided into three types: horizontal, vertical, and portable according to the structure. The basic working principle of the vacuum cleaner is to use the control motor as the power to drive the blades to develop and run at a high speed, generate negative pressure in the confined space, and absorb dust.

　　1. The suction nozzle of the vacuum cleaner motor is wrapped with a lot of sundries, such as small ribbons, hair, dust, and so on. In this case, you can remove the front suction port of the vacuum cleaner to check whether the interior is flat and whether there is any foreign body blockage.

　　Second, the filter in the vacuum cleaner motor may be blocked. There are two conditions:

　　1. Bag-type vacuum cleaner, the container of this vacuum cleaner is a cloth bag or a paper bag. If there is a lot of dust in it, just empty it.

　　2. A vacuum cleaner without eye bags. The filter or chip inside is covered with dust. Make it impossible for players to filter loot. Rinse with water and use as normal. However, if it cannot be used normally after cleaning, it can be considered that the chip is damaged and can only be replaced.

　　3. Air duct leakage

　　It can be checked whether the hose is damaged, whether the connection between the suction tube and the nozzle is correct, whether the suction tube and the shell are connected correctly, and whether the rubber sleeve is closed correctly. The front and rear, upper and lower casings are not installed tightly, and the seals are not damaged.

　　Fourth, the steam cleaner motor speed is slow

　　If the ball bearing is good, check whether the strength of the brush spring is insufficient. If the working strength is insufficient, it is necessary to adjust the spring pressure value of the brush or directly replace the brush and check the position of the brush, which can be adjusted immediately.