+86 15968095745
Home / News / What To Do If The Vacuum Cleaner Motor Does Not Work

News

Provide you with the latest enterprise and industry news.

What To Do If The Vacuum Cleaner Motor Does Not Work

  Now, with the general improvement of the general economic conditions of the masses, the vacuum cleaner has gradually become a very common small household appliance. The reason why the vacuum cleaner can bring convenience to our life is mainly due to the motor. What if the vacuum cleaner motor does not work? How to solve the problem that the vacuum cleaner does not suck? Today, the manufacturer of the YEHAO electric vacuum cleaner motor will show you how to solve problems by yourself when there is a problem with the vacuum cleaner.

  What should I do if the vacuum cleaner motor does not work?

  1. The fuse tube is blown

  Find out the cause, eliminate it, and replace it immediately, otherwise, the damaged electric wire will probably damage the vacuum cleaner motor.

  If the new fuse is still burned out, then the problem is not the fuse. The correct way is to thoroughly check the cause of the burnt fuse, and not continue to replace the fuse. This will only continue to damage the vacuum cleaner. motor.

  2. Circuit break, poor contact

  The circuit structure of the vacuum cleaner is relatively simple, so the investigation work is relatively easy.

  If the fault is found on the power switch, it is mostly caused by poor contact with the switch.

  During the inspection, special attention should be paid to whether the contact of the reel is good or the wire is broken, because the installation position of the reel is usually hidden, and the disassembly and assembly are troublesome, so it is easy to be ignored.

  3. Failure of the vacuum cleaner motor itself

  If there is no problem with the fuse of the vacuum cleaner and the line connection is intact, then it is necessary to check whether the motor of the vacuum cleaner itself is faulty.

  The disconnection usually occurs on the lead-out wire of the vacuum cleaner motor, and most of them can be seen with the naked eye.

  If it is difficult to judge, it can be tested with a multimeter.

  Poor contact mainly occurs between the brush and the commutator (that is, the commutator).

  How to solve the problem that the vacuum cleaner does not suck?

  1. The fan blades are not fixed tightly

  If the fan blade of the vacuum cleaner slides on the motor shaft, the positioning screw of the fan blade must be tightened in time, and the problem can be solved.

  2. The top cover and the middle shell are not tightly sealed

  Check carefully for cracks, or if the screws are tight.

  3. The suction pipe is blocked

  Check whether the suction pipe is blocked, if so, clean up the blockage inside quickly, and then shake off the dust.

  4. The generator is not tightly sealed

  Check the gasket and screwdriver next to the generator to see if there is any looseness, and tighten it in time; if there is a missing screw, make it up in time.

  When there is a problem with the vacuum cleaner, you don’t need to panic too much. Follow the above steps to check step by step to see if you can fix it yourself. If you can’t, you may need to find a professional to deal with it.

PREV:Briefly Describe What Is A BLDC Motor And How Does It Work?
NEXT:What Is The Speed Of The BLDC Motor Related To?